Power Supply & Cables

• Extension 2 m for 12 V cable with 5.5 / 2.1 plug, for OTP #2457630

• Remote Switch OMS-Nano (Observation Management System) used to turn your 10Micron mount on and off from remote
• With 1m connection cable, 3m long LAN-cable and 2m long USB-cable
• 12V/100-240V Power Supply
• Incl. web interface and manual
• Replaces the previous  Remote Switch for 10Micron mounts (#2455030 , € 265,-) , which is no longer produced.

• Hook and loop cable ties with Baader Planetarium logo
• Reusable and closable cable ties for bundling any kind of objects
• 20 mm x 150 mm
• Scope of delivery: 10 x Baader cable ties

• Made for outdoor use at cold temperatures
• Interchangeable EU/US/UK wall plug included
• Output 12.8V DC/ 1.5 Amp (19 Watt), large power reserve even when cold - usable in temperatures from -25°C up to 40°C
• 2.5m (8.25') telescope cord incl. reverse polarity protected, elbowed protective-disconnect plug 5.5mm / 2.1mm
• Not waterproof IP40
• Successor model of the previous 19W Outdoor Power Supply #2457610 (discontinued).

• Grid Filter for electronic devices
• Protects your astronomical equipment (especially mounts) for high-frequency voltage peaks in the network
• Is plugged directly into the socket (230V) between the connection cable of the device
• max. Connected Load oder Power Output?? 1000 W (4A)
• Total length 87,7 cm (without plug)
• Immediately ready for operation after insertion

• suitable for mounts which need a higer voltage of 24V (this cable is equipped with connector for 10Micron GM1000 / GM2000)
• the Baader Planetarium Dual-Mode cable set allows you use two PowerTanks to power those mounts which need 24V, in this case for professional mounts like a 10Micron
• The cable is custom-made and only available directly through Baader Planetarium

• Advantages of LiFePO4: Up to 2000 charge cycles (four times more than lithium-ion & seven times more than sealed lead-acid designs), explosion proof (allowed on airplanes), no memory effect
• LED-panel with red and white LEDs – makes setup und repacking your equipment during the night easier, with red-light as preset for your dark adaptation.
• rubber covered housing, protects against rough handling or moisture. Only in Germany: Protective Disconnect Elbowed Plug for more protection against damage, in case of someone tripping over the cable.
• provides 12V/3A – lasts six hours or longer of typical use of a mount
• two 5V USB-ports (1,5A and 2,5A) e.g. for charging a smartphone or tablet.
• small and light-weight: 19 cm x 7,6 cm, ~1kg
• Scope of delivery: Powertank, battery charger, cable for Celestron telescopes, mounting belt for tripod legs, carrying strap, Protective Disconnect Elbowed Plug

• Y-cable for powering two 12 V instruments with one power supply (for 5.5 / 2.1 plugs)
• For up to 60W total power
• 1x adapter for barrel connector 5,5/2,1 mm
• 2x barrel connectors 5,5/2,1 mm
• Length: 37 cm

NEW VERSION: Baader OMS-Nano – Remote Switch for 10Micron Mounts

The Remote Switch Module is not produced anymore. Therefore, we have redesigned the Remote Switch and manufactured it with a new look and name. The Remote Switch is now part of our OMS (Observatory Management System). 

More details about the Baader OMS-Nano – Remote Switch for 10Micron Mounts

Successor model for GM 4000:
Stabilized Poser-Supply for10Micron GM 2000 / GM 3000 and 4000

The new control of the mounts is again significantly revised and stabilized, which allows us to become more efficient on the power supply side as well.

The Baader OTP 600W is no longer produced and therefore replaced by the Stabilized Power-Supply for GM 2000 / GM 3000 and GM 4000 (#1452070 , € 230,-)

• Network Cable (red) with ColdTemp-specified CAT-7 wire (CAT6a plug)
• Ideally suited for observatory installations. The special sheath of these cables remains elastic and shatterproof, even at low temperatures.
• Normal network cables that are passed through the mount could break or be damaged due to the very small bending radius
• The CAT 7 specification of the cable allows cable management next to power cables in mounts at short range up to 220V without affecting the data.
• available in 3, 5, 15, 30 meters
Learn More

• Additional Protective-Disconnect Connecting Cable, 12V 0,5 m for 60W OTP 2457630/40
• 1x included in 60W OTP scope of supply

• USB 3.0 data cable 10m (!) long
• Type A/Micro-B connector (especially for SkyrisKameras)

• for larger Celestron-Mounts
• Made for outdoor application, water resistant sealed housing. Usable in temperatures from -25°C up to 40°C
• input voltage 100-240V, Output 12.8V / 5A 60W
• Protective-disconnect ellbowed plug German design and quality with EU-wall plug

• Additional Protective-Disconnect Elbowed Plug, for OTP #2457630
• 1x included in 60W OTP scope of supply
• Plud dimensions 2,1 x 5,5 mm, fits also e.g. for the Celestron LiFePO4 PowerTanks

• Input Voltage 110-240 volts, output voltage 24 V / 5 amps (factory setting)
• Connection cable fitting for GM 1000 HPS mount
• Short circuit protection

• Baader USB / RS-232 converter cable (similar to Celestron Item Nr.18775), however, made in Germany
• To connect a device with RS 232 interface to the USB port of a laptop
• Required drivers for Windows, Mac and Linux can be found under the "Downloads" tab

• Baader RS-232 cable for NexStar - made in Germany
• Connects the RJ 11 port of your hand control to the RS 232 port of your PC.
• Necessary to upgrade the Flash EProm Hand Controller and to control the telescope e.g. over NexRemote.
• If your PC / laptop no RS 232 interface, you also require the USB - RS 232 converter cable

• Input voltage 220/230 volts, output voltage 25 volts / 10.5 A factory setting
• Why 25V? The control box of 10 Micron mounts can work with 24V up to a maximum of 27V. Since 24V power supplies can occasionally drop below 24V at high loads and low temperatures - which can lead to the failure of the control computer - the power supplies for GM 2000 HPS, GM 3000 HPS and GM 4000 HPS are therefore preset to 25V. This value has proven itself over the years.
• Output via 4mm banana sockets, fitting for the 10 Micron power cables that come with the mount
• Short circuit protection