Camera Tilters

If i live where there are many houses near me.. and i slowly point telescope towards the sun, wont the sun reflect from my telescope and harm someone living nearby as a concentrated beam?

Do you have any extensions for the eyepiece side of this clamp that could be screwed onto the T-2 thread (which is made accessible by removing the focuser ring) and that could also hold an eyepiece for the clicklock clamp? I would like to be able easily alter the optical path to my different eyepieces using this clamp by removing or inserting such an extension.

You have these 1508153 extensions: https://www.baader-planetarium.com/en/t2-extension-tubes-(7.5--15--40-mm).html They are nice (I have one), but because they are on the telescope side of the clamp, they require a lot of screwing and unscrewing to remove and then reinsert. These extensions will screw onto the revealed T-2 threads on the eyepiece side of the clamp, but they are not suitable for holding an eyepiece. One possible option: is there some kind of adapter that could be added to them and hold an eyepiece for the clicklock clamp?

You have several 1-1/4" T-2 eypiece clamps that might screw onto the revealed T-2 threads of this clamp: https://www.baader-planetarium.com/en/ultrashort-1%C2%BC%22--t-2-klemme.html
https://www.baader-planetarium.com/en/baader-1%C2%BC%22--t-2-eyepiece-holder.html
But because these are separate clamps, the extension is quite large at 20mm or 23.5mm optical path.

Would I would prefer, if you have one, would be either (1) a T-2 thread extension similar to the 1508153 extensions but that would be suitable for holding an eyepiece and use the clicklock that is already in this clamp or (2) a T-2 thread adapter for the 1508153 extensions that could hold an eyepiece in position for the clicklock clamp if those extensions were screwed onto the T-2 thread of this clamp.

Please let me know if you have such a thing!

Thank you very much for your assistance.

Best,

Joseph Guth

Can I use this filter in an original William Optics Redact 51 holder?

I would like to use this focuser on a Sky-Watcher Equinox 80ED. I realize this question may have been asked before however, I have additional information. The OTA to which the focuser needs to fit ends with an M84x1 male thread. Do you have an appropriate adapter or can one be custom built? I can send detailed photographs if necessary...

I have connected to my internet router (as is the 10-micron mount), but I can't naviage to http://192.168.0.123/index.htm, I get a timeout error. I can see it as a wired client in the router settings.