Tripod adapter flanges

Die Flügel der Schraube zur Befestigung der Montierung lässt sich bei voll eingefahrenen Beinen des T-Pod-Stativ nicht drehen. Man muss also die Beine etwas ausfahren. Durch eine längere Schraube ließe sich das Problem lösen. dann kämen die Flügel tiefer und würden nicht mehr an den Stativbeinen hängen bleiben. Ansonsten ist der Flansch sehr solide gemacht.

I had bought a used eq8 pier-tripod and needed an adapter for my cgem dx mount head. I was just about to order the cgem adapter when i saw this, even though there was no image intookna chance and bougth this one. I got the package and it was heavy.. I took me a little time to figure out what actually was in the package... One i figured that out i drilled suitable holes in the eq8 pier tripod top plate and attached the adapter, then I had to temove the top section of the cgem dx tripod and attach it to the cgem dx mont head and finally attach the mount head on the adapter. Very sturdy result and it looks nice the total height is lower the with the cgem dx tripod, a bit heavier but smaller :) I had to reuse the screws from the cgem dx tripod to attach everything to the adapeter, the requires an allen key. It would be nice to have icluded with the adapter a set of screws with wings or similar arrangment to allow for tightening by hand :)