Remote Switch for 10Micron mounts
The Remote Switch is perfect for being installed in an observatory. For reasons of failure safety, we have placed great emphasis on a safe standard. Therefore the module does not communicate via USB, but only via LAN. The module can be connected to the same LAN network as the mount. After installation, the module can be accessed in the network via the assigned IP address via any browser. If your router has WiFi, you can also use your smartphone, if it is connected to the same network. Simply enter the IP in the browser or use the free app. This article is prepared by us so that it can be used directly with a GM mount. All cables are prefabricated and enclosed. In addition, we have writen an instruction manual, which goes into the use with a GM mount decidedly.
A 10Micron GM mount can be switched on and off remotely via the external switching device expert net control 2104. For this, the 3-pin stereo jack (8) EXT SWITCH is connected in parallel with its two front contacts (stereo left and right, without ground) to the ON / OFF switch (3). This is a so-called rocker switch which is only closed for the duration of pressing the rocker (approx. 3s).
The expert net control 2104 switching module must be operated as a rocker switch. It must close the contact for one to three seconds, but not continuously: Switch on – wait for 3s – switch off. The mount is now switched on. Same procedure for switching off the mount: Switch on – wait for 3s – switch off.
- 12V/100-240V Power Supply
- Jack for connection of the Control Box of Mount
- 1m Network Cable
- Driver, Tools & Manual
- incl. instruction manual
|Adaptable to||10micron GM-Mounts|
You may also be interested in the following product(s)
€ 15,800.00 Price excl. German VAT tax (19%): € 13,277.31
€ 29.00 Price excl. German VAT tax (19%): € 24.37
€ 3.50 Price excl. German VAT tax (19%): € 2.94
€ 130.00 Price excl. German VAT tax (19%): € 109.24
€ 12.50 Price excl. German VAT tax (19%): € 10.50